Tanzania specifies the requirements for the Code of safety for sodium hydroxide, inlet air cleaning equipment for internal combustion engines and compressors, Iron and steel products, industrial wire cloth for general purposes, pneumatic tyres for passenger cars. Code of safety for sodium hydroxide The Standard specifies a code of safety concerning hazards relating to sodium hydroxide. It describes the properties and essential information for the safe handling and use of sodium hydroxide click here for notification Sodium hydroxide The Standard specifies requirements, sampling and methods of tests for sodium hydroxide suitable for use in rayon, cosmetic, textile, soap, paper and other similar industries. The specification does not apply to sodium hydroxide used for pharmaceutical, photographical or food processing purposes. click here for notification Iron and steel products The standard cover the requirements for commercial steel wool of different grades. The commercial steel wool shall be of the following grades, Grade 0000 (Super fine) Grade 000 (Extra fine) Grade 00 (Very fine) Grade 0 (Fine) Grade 1 (Medium) Grade 2 (Coarse) Grade 3 (Very coarse) click here for notification INDUSTRIAL WIRE CLOTH FOR GENERAL PURPOSES The standard lays down the minimum requirements of material, dimensions and construction of woven wire cloth used for general purposes. This draft standard does not cover wire cloth used for test sieves click here for notification Pneumatic tyres for passenger cars The Standard specifies tyre dimensions designation and marking requirements; and load ratings. It also gives laboratory test requirements for bead unseating resistance, strength, endurance and high-speed performance for tyres primarily intended for passengers click here for notification Inlet air cleaning equipment for internal combustion engines and compressors The Standard establishes and specifies uniform test procedures, conditions, equipment, and a performance report to permit the direct laboratory performance comparison of air cleaners. The basic performance characteristics of greatest interest are air flow restriction or differential pressure, dust collection efficiency, dust capacity, and oil carry-over on oil bath air cleaners. This test code therefore deals with the measurement of these parameters. The Standard is applicable to air cleaners used on internal combustion engines and compressors generally used in automotive and industrial applications click here for notification products covered: Sodium hydroxide, Iron and steel products, industrial wire cloth, Pneumatic tyres, Inlet air cleaning equipment HS Code: 2815, 72, 4011 Proposed date of adoption: End of December 2017 Proposed date of entry into force: 6 months after Gazetted in Government Gazette Final date for comments: 60 days from notification |