Uganda proposed Specification for Motorcycle rubber wheel inner tubes and Petroleum Industry – Above ground storage tanks of petroleum products Uganda National Bureau of Standards proposed following: 1)Specification for Motorcycle rubber wheel inner tubes: Uganda Standard specifies requirements, sampling and test methods for motorcycle inner tubes made of natural rubber (hereinafter referred to as inner tube). Products covered: Motorcycle rubber wheel, Inner tubes of rubber HS code: 4013 Click Here for Notification 2)Specification for Petroleum Industry - Above ground storage tanks of petroleum products Siting, design and construction of large consumer Installations and Handling of petroleum products and their derivatives: Uganda Standard covers the layout and design of petroleum bulk depots, and the installation of equipment of the types normally used for the handling, storage and distribution of petroleum products and their derivatives, other than equipment that is used for storage and dispensing on consumer premises (including service stations) and for which relevant standards exist. A design will meet the requirements of this standard if it complies with any one of the approved standards listed. However, such a standard shall be applied in its entirety (where applicable). For example, the product classification of one standard cannot be used in combination with the design of another standard. Products covered: Reservoirs, tanks, vats and similar containers, of a capacity exceeding 300 litres HS code: 392510 Click Here for Notification Proposed date of adoption: June, 2018 Proposed date of entry into force: NA Final date for comments: 29-03-2018 |